KioshiOriginal postFremont, CA · Dec 19, 2009#1The rubber grommet cover used to prevent from condensation building up inside the headlights.....how did you guys manage to put that over the HID bulbs?
I have HIDs i bought from Garm, H4....and that small hole won't go through it...
What has everyone with those HIDs or some other H4 brand, done to overcome this?
Replies 9
djct_wattThailand · Dec 19, 2009#2I was able to force the right hand side on, but there is not enough space on the left hand side to get my hands in. Rubber stretches.
KioshiThread starterFremont, CA · Dec 19, 2009#3Rubber does stretch but the small opening does not stretch enough to where it can sit at the base of the HID bulb to where the three little tabs are to sit in the headlight housing correctly....
Did you force through the front of the HIDs or through the back? Because through the back the ballast is connected and i can't remove those wires...there put inside the unit~
djct_wattThailand · Dec 19, 2009#4My HID's had quick connects between the ballast and the bulb. . . I've never seen HID's that had fixed cables to the bulb!!!!! How do you change the bulbs when they (eventually) fry? Are you sure there is no wire harness disconnect? It took a lot of work, but it fit (and I have dual beam kit with a large metal control servo for the high/low shield).
I forced 'em through from the back side. . . that sounds so wrong. . .
KioshiThread starterFremont, CA · Dec 19, 2009#5 Originally Posted by
djct_watt ↑ I forced 'em through from the back side. . . that sounds so wrong. . .
😆 that made my day, sir.
Sorry, I overlooked the wires...too many wires going here and there.🙄
Yeah, i removed the wires and had to cut 1/2 inch or less at the tip of the rubber to fit them tightly from the back side.
Stupid thing though, I put the sealant on before actually putting the bulb in first and the retainer clip on~~
silicon adhesive sealant doesn't come off the hands very easily.
Thank you for responding and helping out with this, really appreciate it👍
Hmm...what brand or where did you get yours from? Mine has this shielf half way around the bulb itself, i think its a glare shield as some have called it~
djct_wattThailand · Dec 19, 2009#6I got mine from the Bangkok Motor Show in Thailand (just like the LA or SF autoshow). Contrary to the shows in the states, people come to these shows to buy new cars as dealers set up sales stations and offer great deals on the cars. They also have a smaller area for modded cars and parts. I picked up my set there for a HUGE discount.
The brand is Equator (probably some made in china stuff) and it uses some sort of servo to pull the bulb in and out of the shield. The craftmanship of the kit is actually REALLY good and it came with a relay and fuse prewired into a harness! Not a bad deal for $USD 40.
LA YarisLos Angeles CA · Dec 19, 2009#7I just Cut a slit in mine and put it around the light and wires
sqcompBack at home · Dec 20, 2009#8x2 for mine and my wife's Tacoma...
kargoboySt. Augustine, FL · Dec 20, 2009#9 Originally Posted by
LA Yaris ↑ I just Cut a slit in mine and put it around the light and wires
I did that, too.
Black YarisToledo, OH · Dec 20, 2009#10i pushed all the wires though no problem on the Yaris, xB and the Rav