BadgerOriginal postUK · Nov 25, 2009#1My dealer says this is 'normal' but I drive 4 different cars at weekend and I've never seen this before. When changing up 1-2, 2-3 as soon as the clutch is depressed the engine over-revs, not every time but around 20% of gear changes. This happens both cold and hot and has done same in higher gears but not so frequent. I've tried various driving positions but it still happens. I've been VERY careful about releasing throttle to no avail - this did not happen during my 1 hour test drive (I'm going to visit dealer to try another demo car).
Mind you my dealer also says the stop-start system works by disengaging the flywheel!!!
Is this really 'normal' for a 2 month old Yaris? or is this 'normal' for dealers only
Replies 26
1NZYaris1New Zealand · Nov 25, 2009#2Take your foot of the gas pedal sooner , thats why it does not do it on down shifts , because your right foot is on the brake .
IllusionXBrossard, QC · Nov 25, 2009#3I have had friends drive my yaris before. They often rev'ed it up on an up shift. (ie, 1-2, 2-3)
This had happened to me when i did the test drive before i bought my yaris, and also happened when i first got my yaris. At the time, i already knew about the drive-by-wire thing, so i adjusted my foot according to the response time of the throttle.
Driving different cars does not mean you are driving the yaris properly. Try lifting your foot off the throttle a fraction of a second earlier than you usually do as you depresse the clutch
SilverBackEl Monte, Ca · Nov 26, 2009#4 Originally Posted by
Badger ↑ My dealer says this is 'normal' but I drive 4 different cars at weekend and I've never seen this before. When changing up 1-2, 2-3 as soon as the clutch is depressed the engine over-revs, not every time but around 20% of gear changes. This happens both cold and hot and has done same in higher gears but not so frequent. I've tried various driving positions but it still happens. I've been VERY careful about releasing throttle to no avail - this did not happen during my 1 hour test drive (I'm going to visit dealer to try another demo car).
Mind you my dealer also says the stop-start system works by disengaging the flywheel!!!
Is this really 'normal' for a 2 month old Yaris? or is this 'normal' for dealers only
I see you're the only Yaris that's been affected by Toyota's "stuck gas pedal" recall 😆
I had this rev problem until I decide to let off the gas completely a full second before shifting. Just take it slow and easy.
AlexNet0Rockland, ME · Nov 26, 2009#5 Originally Posted by
k r a y z e e . j o j o ↑ I see you're the only Yaris that's been affected by Toyota's "stuck gas pedal" recall 😆
I had this rev problem until I decide to let off the gas completely a full second before shifting. Just take it slow and easy.
+1, I can see why OP is wondering however. just takes getting used to.
jambo101Montreal Canada · Nov 26, 2009#6I have the same problem with some over revving when shifting🤷think it has something to do with fly by wire throttle🤷 i just live with it,suppose i could take my foot off the gas a few seconds before disengaging the clutch if i thought it was a big deal..
BuildCodeNorthern Illinois · Nov 27, 2009#7yup, this just takes getting used to, I don't think it has anything to do with the fly by wire. I think it's just a small 4 banger thing from my experience (hyudai elantra did it before getting used to it), manual cars with bigger engines I've driven don't do it unless you are in too high of a gear and trying to accelerate.
Richie76Blue Mountains NSW Australia · Nov 28, 2009#8I thought it was an emissions thing.. Our V8's over here with the fly by wire do the same thing... It's something to do with helping burning the excess fuel when lifting off the throttle..
BadgerThread starterUK · Jan 1, 2010#9thanks to those who have responded, I've done some experiments. I can get over revving with no foot on throttle (just crash out of gear and push down on clutch to go up gear. it seems to be something in the ECU that's being kicked off when it senses a gear change
I'm not talking a 200 RPM increase, we're talking 500-1,000 RPM change. 200 is what I would call normal with my other young cars with similar technology. Most of my gear changes are at low revs, there is hardly any over -revving when changing gear at 4K or above. Richie76 may have nailed it with the emmisions thing, Another of my (2 year old) cars will flood if driven < 20 feet (like taking out of garage). It was explained to me that modern cars have a much more 'sealed' fuel system recycling unburnt vapours back into injectors/carbs rather than the old enging/exhaust/athmosphere system
09SedanPolarWhiteMTSouthern Illinois · Sep 5, 2010#10Happens to me too, I thought it was the weirdest thing in the world when I first noticed it. Is it because of the drive-by-wire or something?
It happens to keep the revs up between shifts.be worried when it revs to 7000rpms by itself.
cali yarisCanoga Park, CA · Sep 5, 2010#12mine never did that
RedRideMiddletown, NY · Sep 5, 2010#13Mine never did it either.
In fact I never experience any problems with the DBW throttle.
TLyttleKeremeos BC · Sep 5, 2010#14Hm. I have had the same problem, and both the DBW and the emission control explanations make sense to me. I truly hate the Yaris throttle, not only for the over-rev, but because the throttle is so damn light: on long trips it gives me shinsplints, even after 3+ years. If I thought I could put an honest spring in the system for throttle feel (my buddy's Echo comes to mind), I certainly would!
xyntaxksa · Aug 8, 2014#15have the same problem. just changed the oil pressure control valve.
sheekeebutMississauga, GTA, Toronto, ON · Aug 8, 2014#16I noticed the same thing when I went from Civics and Integras to Yaris.
I thought it's due to such an early version of the drive by wire, combined with the throttle response of an economy tuned engine.
I needed about 2000 km of driving to finally get a feel for the pedals. Realized mainly I was seated too close to the pedals. Backing off my seat allowed quicker clutch (dis)engagement, and lighter throttle manipulation.
dj92mid-western Germany · Aug 9, 2014#17I think about making a video of me driving with mine, shifting fast is quite easy and it does not rev up at all.
It simply keeps up the RPM for a fraction of seconds, of course the engine revs up if the load is reduced (by disengaging) and the throttle angle stays the same :P
sheekeebutMississauga, GTA, Toronto, ON · Aug 10, 2014#18dj92 is right. Would be nice if someone in a Yaris post one of those split-screen videos, showing stuff like pedalwork, steering, gauges and road.
Heck, with all these phone apps and tools, can't one even give acceleration and weight transfer readings?
dj92mid-western Germany · Aug 11, 2014#19It will be some work to build two fixtures, but you've convinced me to do so :)
I'll begin as soon as I'm home again (this weekend or the beginning of the next week)
sheekeebutMississauga, GTA, Toronto, ON · Aug 11, 2014#20dj92mid-western Germany · Aug 20, 2014#21I have not forgotten my plan, sadly I'm still looking for the best way to mount my cameras without spending money ;)
DeatheggCA · Aug 20, 2014#22 Originally Posted by
Badger ↑ I'm not talking a 200 RPM increase, we're talking 500-1,000 RPM change. 200 is what I would call normal with my other young cars with similar technology. Most of my gear changes are at low revs, there is hardly any over -revving when changing gear at 4K or above. Richie76 may have nailed it with the emmisions thing, Another of my (2 year old) cars will flood if driven < 20 feet (like taking out of garage). It was explained to me that modern cars have a much more 'sealed' fuel system recycling unburnt vapours back into injectors/carbs rather than the old enging/exhaust/athmosphere system
500-1000 rpm is really excessive! My '10 does it, but certainly not to that extent. Have the dealer or your mechanic test drive it with you in the car as well. Just a stupid question (sorry): you're not a beginner clutch driver, are you? Just saying that sometimes beginners stay on the throttle too long, or simply do not have the coordination for the clutch/throttle down pat, and it may appear that your engine is over-revving because of it.
dj92mid-western Germany · Aug 22, 2014#23Is it true that so many north americans have problems handling a manual gearbox?
I have no records yet, but today I have observed how I am shifting upwards gently (as I use to do it subconsciously all the time):
You have to release the throttle and press the accelerator down both not too fast at the same time.
It takes just a little time of practice to find out the minimum time and the maximum pedal speed (don't think you can slam a pedal without letting yout car jump) to do this.
For me, it's about 1,5-2 seconds.
Downshifting is almost the same, the clutch release speed is almost always a tradeoff between comfort and lifetime.
I don't really bother about it as I release it rather fast (but still without bigger jumps) and know how to replace it on my own (stealership's pricing is totally nuts, especially for spare parts).
ExiwolfmanWasaga beach · Aug 22, 2014#24Love how ppl always complain about dealership ...funny is that lots of cars come back to us to have it done right , really now who do u want to work on ur Toyota a guy that knows them inside out and specializes mainly on that brand of car or someone that thinks he knows it all ...also don't cheap out on parts u get what u pay for .
sent from my S4 on Mars
dj92mid-western Germany · Aug 22, 2014#25It's not about the work fees (which are, however, quite high)
>1000$ for a plain steering gear, 35 for a tiny plastic rail holding the rear bumper, 300 for a tiny seat cushion (just some foam and fabric) and almost the same for one strut is nothing but ripoff, keeping in mind that the latter one from a good brand (Bilstein e.g.) for other cars can be had for not even half of that.
My experience was, is and (I think so) will be that I have to do on my own what has to be done properly.
I have a rental garage at hand where I have access to enough tools for even working on the clutch.
It would not be the first drivetrain and by far not the first car for me to work on ;)
ExiwolfmanWasaga beach · Aug 22, 2014#26And that is the best way ...do it on ur own :)
sent from my S4 on Mars
IllusionXBrossard, QC · Aug 22, 2014#27Yeah i always try to do my own.
It is 109.95$/hr at my local Toyota dealer vs 54$ at a trusted friend's garage.