Yarisworld Archive

Help with header install - I'm stuck

12 posts · 4,621 views

fmicleOriginal postSan Jose, CA, USA · Sep 19, 2009#1
Everything was going great, I got the stock header out, had disconnected the O2 sensor, moved the donut from the stock header to the new one and started to remove the O2 sensor from the old header. It was very difficult, so I went and bought a longer wrench, so I can apply more force. After a few revolutions, just enough to see the washers inbetween moving, it got stuck. I've been trying really hard to get it moving again, but no luck. I sprayed a little W40 at the base of the bolt, but so far it hasn't helped...

Any advice? Should I try a bigger wrench? I'm slowly starting to ruin the nut with all the force. What should I do? 🤷

Replies 11

YarisSedanCalifornia - Bay Area · Sep 19, 2009#2
tighten it
then loosen it
tighten it again
then loosen again

its a trick ive used with boogered hard to come out spark plugs it may work with o2 sensor
BrianRiverside, CA · Sep 19, 2009#3
It also helps to use an O2 sensor socket
fmicleThread starterSan Jose, CA, USA · Sep 19, 2009#4
Yeah, I was wondering if I can get the O2 sensor from a Toyota dealer if I ruin it. Does anyone have an idea how much the part costs?

And also, can I drive the car without the O2 sensor in place? Until I get a replacement?
BrianRiverside, CA · Sep 19, 2009#5
You can order a new one but they're over $100 I think. I wouldn't recommend drivng without one.
supmetSouthern California · Sep 20, 2009#6
Originally Posted by fmicle ↑
Yeah, I was wondering if I can get the O2 sensor from a Toyota dealer if I ruin it. Does anyone have an idea how much the part costs?
Originally Posted by hatchbackkid82 ↑
Just bought a brand new primary O2 sensor that cost me $171👎, the original one broke when I was installing my header.
What did you buy today?

i lol'd
fmicleThread starterSan Jose, CA, USA · Sep 20, 2009#7
Alright, I'm done, it was a bitch, to say the least 🙁

I took my bike rack apart so I could use the main bar/pipe as an extension to my wrench. Then I slowly loosened the O2 sensor until it came off. I noticed that the thread on the bolt is 75% ruined, but I was able to mount it on the new header just fine.

Another disappointment came when I realized I wasn't going to be able to attach the header to the engine bracket. No matter what I tried, the holes just wouldn't align. So I used a smaller diameter bolt and nut to fasten it, instead of the original thicker bolt that threads into the header collar. I hope it's strong enough.

Then I took it for a ride and everything feels alright 🙂

Did anyone experience similar issues with the fitment?
BrianRiverside, CA · Sep 20, 2009#8
Mine fit perfectly.
YotaYarisSA TX · Sep 24, 2009#9
What header did you buy? Was it a DC Sports?
TamagoOff Grid · Sep 24, 2009#10
why not a box end wrench? you're taking the manifold out of the car anyway, just unclip it from the harness and do this on the ground?
bronsinnj · Sep 24, 2009#11
Next time heat the header with a torch near the sensor...
hatchbackkid82. · Sep 29, 2009#12
mine broke too i had to pay 180 for a new one, my header lined up perfectly, car feels great now