how do you take off the front Toyota emblem off??
how do you take off the front toyota emblem off
15 posts · 20,169 views
Replies 14
You have to remove the retaining pins from the top of the bumper to gain access to the rear of the emblem.
There are are retainng clips holding the emblem on..
There are are retainng clips holding the emblem on..
in all honesty...
PULL VERY HARD
it will be fine
we did this in the parking lot of a movie theatre
PULL VERY HARD
it will be fine
we did this in the parking lot of a movie theatre
check my thread in pic's... I removed the middle under panel. you need a decent socket wrench, rhino ramps and a skinny arm, rofl. That or just pull hard ;)
omg...this topic pops up almost every month haha
Easiest way - look at your emblem facing your car.
Right botton side 5:00 and left bottom side 8:00.... stick your middle finger in those holes and pull the tabs outward. Thats all you have to do, no need to take off bumper or anything....
Easiest way - look at your emblem facing your car.
Right botton side 5:00 and left bottom side 8:00.... stick your middle finger in those holes and pull the tabs outward. Thats all you have to do, no need to take off bumper or anything....
Use an old credit card and slide it around the emblem when you hit the clips it will pop out.
use ur pinky..takes 5 seconds..
OK guys, you made your point. Just (carefully) pull it out. 🙂
lol yea i think everyone asks this once a week. i just reached behind the bumper from underneath and pushed the clips with my fingers and it almost jumped off the car. its cake.
how did it go?
Yeah a set of channel locks with tape on the "mouth" of the channel locks is your best friend . Takes like 5 seconds to with a quick stright outwards tug .Originally Posted by BrazdonW ↑in all honesty...
PULL VERY HARD
it will be fine
we did this in the parking lot of a movie theatre
wow..the credit card method worked like magic
I just got a good hold of mine and gave it a good tug. Off it came.
Blow dryer to melt the glue underneath the emblem and use a fishing line to slide it right through and take it off. Its pretty easy!
First, grab a hole saw......