Hey guys, I just install my personal steering wheel, Works Bell short hub and quick release yesterday. Since I can't really find a good write up for them, here I will show all the detail of my installation.
Car:
MY09 LB
Parts:
Personal Steering wheel, Works Bell hub and quick release
Tools needed:
3/8 ratchet, long extension, 1/4 Torx T30, 3/8 to 1/4 adaptor for T30(see pic), 19mm long socket, Philip screw drive
Please read carefully for all detail, and of course I'm NOT responsible for any damage or warranty related issue, if you try to attempt this installation. Do it at YOUR OWN RISK!
Ok, let start taking the negative terminal off first to avoid the airbag deloy during installation. Look at the stock steering wheel, their is two T30 torx screw on the side to take off the airbag, you can't take the screw out, but just turn them all the way loose. Then you wiggle the airbag a bit, it will come loose. You will see there is two plugs attach to the airbag, use a small flat head to pry the yellow tap up to disconnect them(see pic)




Car:
MY09 LB
Parts:
Personal Steering wheel, Works Bell hub and quick release
Tools needed:
3/8 ratchet, long extension, 1/4 Torx T30, 3/8 to 1/4 adaptor for T30(see pic), 19mm long socket, Philip screw drive
Please read carefully for all detail, and of course I'm NOT responsible for any damage or warranty related issue, if you try to attempt this installation. Do it at YOUR OWN RISK!
Ok, let start taking the negative terminal off first to avoid the airbag deloy during installation. Look at the stock steering wheel, their is two T30 torx screw on the side to take off the airbag, you can't take the screw out, but just turn them all the way loose. Then you wiggle the airbag a bit, it will come loose. You will see there is two plugs attach to the airbag, use a small flat head to pry the yellow tap up to disconnect them(see pic)



















