Yarisworld Archive

NST shifter cable bushing users: Lube up!

11 posts · 7,449 views

schleppyOriginal postBoston, MA · Jul 2, 2009#1
I recently installed some NST shifter cable bushings and I very much like them. I did notice that the shifter felt a bit "gritty" when rowing it around after installed the bushings. My car only has 5000 miles on it, so I figured the grit must be from the shiny NST bushings rubbing against the grit in the bushing carrier.

After spraying some Dupont teflon lube onto and around both bushings I was rewarded with a very nice, smooth shifter action.

So, go out there and lube those shifter cable bushings (if you haven't already)!

Replies 10

CASTREXCosta Rica · Jul 3, 2009#2
I've been saying the same...

Some wd40 brought new life to my SSK / cable bushings combo

👍
KioshiFremont, CA · Jul 3, 2009#3
I'll have to keep this in mind when i get the cable bushings...
schleppyThread starterBoston, MA · Jul 3, 2009#4
Originally Posted by CASTREX ↑
I've been saying the same...

Some wd40 brought new life to my SSK / cable bushings combo

👍
Keep in mind that WD40 isn't a true lubricant, it's a water displacer (hence the "wd"). I would put a longer lasting lube in there.
jkuchtaL.A. · Jul 3, 2009#5
I use a little bit of Tri-Flow. It's pretty Bitchin' stuff that has one of those straw applicators that makes getting the stuff on the the bushings a piece of cake.
DerFlosserUSA · Jul 4, 2009#6
WD-40 is a lubricant...it doesn't just displace water. The problem that I have with WD-40 is that it tends to attract dust and dirt. A needle applied teflon lube is a better choice.
AlexNet0Rockland, ME · Jul 4, 2009#7
I dont have the NST bushing set, but I shot some white lithuim on every joint in my shift linkage when I was trying to kill the squeak, and since then it shift sooooo much smoother with the engine bay NST SSK
schleppyThread starterBoston, MA · Jul 4, 2009#8
Originally Posted by DerFlosser ↑
WD-40 is a lubricant...it doesn't just displace water. The problem that I have with WD-40 is that it tends to attract dust and dirt. A needle applied teflon lube is a better choice.
It is, but it's not very long lasting at all. And as you mentioned it attracts a lot of crap.
DerFlosserUSA · Jul 5, 2009#9
Originally Posted by schleppy ↑
It is, but it's not very long lasting at all. And as you mentioned it attracts a lot of crap.
True...it doesn't last very long at all. 👍
AlexNet0Rockland, ME · Jul 5, 2009#10
Schleppy you coming to the Natick, MA meet? we need more people.

</threadjack>
severous01SE Texas · Jul 5, 2009#11
moly-lube or graphite. any oil will attract dirt and cause u serious problems in the future. plus cleaning them is a pain when you grease or oil them up.