Yarisworld Archive

I CANNOT get the front strut nut off

10 posts · 7,158 views

naossoanOriginal postMB, Canada · May 29, 2009#1
I'm trying to install my TEIN springs. I got the back done easy peezy. I've got everything off the front necessary to access the front strut bolts with the alan key inside and 17mm nut.

I CANNOT use a box wrench to turn it, it just starts to stip the upper part of the bolt. I CANNOT use a ratchet with a socket to loosten it because I need the alan key to hold the centre from moving.

How the bloody hell do I get these nuts off? The spring install guide makes it sound easy peezy but that just is NOT happening.

Does anyone know if a socket with a hexagonal outside (instead of completely round) exists? You know then I could use the socket and use a large like 19 or 21mm box wrench to turn the socket...

OR anyone have any other teniques?

Thanks

Replies 9

1NZYaris1New Zealand · May 29, 2009#2
remove the top panels plastic and steel , wiper's then use a impact gun
electric or air powered , also make sure you are turnning the nut counter clock wise 😁
naossoanThread starterMB, Canada · May 29, 2009#3
I dont think you understand what I mean, I've already done all that.

But I got them off I went and bought some better vice grips.
DerFlosserUSA · May 29, 2009#4
Originally Posted by Thirty-Nine ↑
You need a 17mm off-set wrench. It's the only good way to get that nut off.

17mm wrench and the correct allen wrench, then it will come off.
Agreed.
1NZYaris1New Zealand · May 29, 2009#5
If you are trying too remove the first nut on the strut , do it while there is upward pressure on the strut ,
ie with wheel on and sitting on the ground or with jack under wheel hub ,
this takes some of the pressure of that nut .
if you are talking about the secound nut use spring compressor to take up spring pressure , of nut .
YarisSedanCalifornia - Bay Area · May 29, 2009#6
What thirtynine said. I used a offset wrench and a allen key. I used a small pipe on the end of the allen key to hold it in place and a long handle offset box wrench. Came off with a little effort without having to remove the cowl.
naossoanThread starterMB, Canada · May 30, 2009#8
ok thanks guys.

I eventually got them off by using some vice grips with a 17mm socket and a alan wrench...

I have another problem now though. I'll make a different thread though as it's a totally different problem.

I'll have to pick me up some wrenches.
cali yarisCanoga Park, CA · May 30, 2009#9
^ correct answers, offset box end wrench FTW, or air tools.
naossoanThread starterMB, Canada · May 30, 2009#10
Think these or these will work?

I can't buy something online and wait a week or something to get it, I need the tools now...and you'll see why from this thread.