Yarisworld Archive

09 Fog Light Install

10 posts · 4,472 views

MGarganoOriginal postNJ · May 12, 2009#1
I just want to make sure I'm doing this right before I finish so I don't have to tear everything apart again. I'm installing Micro Image fogs ( http://shop.microimageonline.com/pro...&productId=103 ) in an 09 LB and will be using the OEM stalk, not the supplied switch. I followed the supplied Toyota installation manual and I think I have a bit of a problem. Step #12 shows 2 wires (red/brown & red/white) connecting to pins 1 & 2 in the fuse panel but.... the wiring harness I received has 2 solid red wires. Does it matter which wires goes to which pin?

I used the headlight ground (near the air cleaner assembly) to ground the fogs and plugged in the supplied relay under the dash. Am I correct in assuming all that's left for me to do is install the OEM stalk? No more wiring necessary?

Replies 9

Liu997Hicksville, LI · May 12, 2009#2
You don't want your switch? I'll pay you for that since mines is busted up.
MGarganoThread starterNJ · May 12, 2009#3
I have the switch and the whole in-cabin harness. How much?
Liu997Hicksville, LI · May 12, 2009#4
I only need the switch, I already have my fogs installed
MGarganoThread starterNJ · May 12, 2009#5
Ok make me a reasonable offer for the switch and it's yours
Liu997Hicksville, LI · May 12, 2009#6
check pm
CTScottUSA, CT · May 12, 2009#7
Originally Posted by MGargano ↑
I just want to make sure I'm doing this right before I finish so I don't have to tear everything apart again. I'm installing Micro Image fogs ( http://shop.microimageonline.com/pro...&productId=103 ) in an 09 LB and will be using the OEM stalk, not the supplied switch. I followed the supplied Toyota installation manual and I think I have a bit of a problem. Step #12 shows 2 wires (red/brown & red/white) connecting to pins 1 & 2 in the fuse panel but.... the wiring harness I received has 2 solid red wires. Does it matter which wires goes to which pin?

I used the headlight ground (near the air cleaner assembly) to ground the fogs and plugged in the supplied relay under the dash. Am I correct in assuming all that's left for me to do is install the OEM stalk? No more wiring necessary?
with an aftermarket kit, you can connect to either pin 1 or pin 2 (OEM brings right and left separately to each).

Don't forget about the FOG fuse as well. Other than that and the stalk you are good to go.
MGarganoThread starterNJ · May 12, 2009#8
Is it a problem if I used both wires/pins?
CTScottUSA, CT · May 12, 2009#9
Originally Posted by MGargano ↑
Is it a problem if I used both wires/pins?
No problem - Makes it more OEM.

1 is right, 2 is left...
MGarganoThread starterNJ · May 12, 2009#10
Ok good to know. Next up is the fog & cruise stalk and leather steering wheel