Yarisworld Archive

whistle?

12 posts · 4,824 views

silver_echoOriginal postSpokane, WA · Feb 28, 2009#1
anyone else notice the slight whistle from the intake manifold? normal? i think that it is normal as i have heard it on other echos that i see as well as 1st gen xBs and xAs... very low on gas pedal pressure, usually low in RPM almost sounds like a vacuum leak, but no codes, and it only sounds at a specific pedal point...

Replies 11

TamagoOff Grid · Feb 28, 2009#2
it's a common noise, usually louder when you have an intake.
rningonfumesSoCal · Feb 28, 2009#3
Just in case, check for holes or breaks in the rubber/plastic.
TamagoOff Grid · Feb 28, 2009#4
Originally Posted by rningonfumes ↑
Just in case, check for holes or breaks in the rubber/plastic.
you'd have a CEL if there were leaks between MAF and engine.
rningonfumesSoCal · Feb 28, 2009#5
Not necessarily, had the rubber on my Camry's 4cylinder go bad, took me a week realize the NEW (lol) whoosing/wheezing sound was a tear-- no CEL. Then again the Yaris is newer, you could be right.

Doesn't hurt to look, does it?

For the record, I don't hear any sound from my stock unit.
silver_echoThread starterSpokane, WA · Feb 28, 2009#6
actually mine is an 01 echo... same car, same motor, and has been doing it since i got into it with 10k miles just never really bothered with it... i think it has something to do with the fact that the intake manifold is plastic
TamagoOff Grid · Feb 28, 2009#7
Originally Posted by rningonfumes ↑
Not necessarily, had the rubber on my Camry's 4cylinder go bad, took me a week realize the NEW (lol) whoosing/wheezing sound was a tear-- no CEL. Then again the Yaris is newer, you could be right.

Doesn't hurt to look, does it?

For the record, I don't hear any sound from my stock unit.
he's an echo

shares ECU(kinda) and throttle body with me. y'all are DBW and use a different MAF etc.
silver_echoThread starterSpokane, WA · Feb 28, 2009#8
have to say it, HAHA i typed faster!... 😁
TamagoOff Grid · Feb 28, 2009#9
Originally Posted by silver_echo ↑
actually mine is an 01 echo... same car, same motor, and has been doing it since i got into it with 10k miles just never really bothered with it... i think it has something to do with the fact that the intake manifold is plastic
same engine block, but very very many differences between the yaris 1nz and our (echo and xa/xb) 1nz... learning more differences every day :(
TamagoOff Grid · Feb 28, 2009#10
Originally Posted by silver_echo ↑
have to say it, HAHA i typed faster!... 😁
3:18 > 3:18 :(
silver_echoThread starterSpokane, WA · Feb 28, 2009#11
aren't they all the 1nz-fe? should be the same all the way across, and it looks like the same manifold one the yar
TamagoOff Grid · Feb 28, 2009#12
Originally Posted by silver_echo ↑
aren't they all the 1nz-fe? should be the same all the way across, and it looks like the same manifold one the yar

no sir.

different intake manifold
different throttle body (theirs is drive by wire, ours is obviously cable)
different mass airflow sensor (we have an older denso unit, shared ironically with the STI)

etc etc. the list goes on.