Yarisworld Archive

DIY: Make Your Own Short Shifter

8 posts · 6,581 views

33OHOriginal postDover, Ohio · Feb 15, 2009#1
First, here is the final product. 3.25" shorter shifter. I've had this weighted knob on it, or right now I'm using the stock shift knob.
Picture not included in this copyPicture not included in this copyPicture not included in this copyPicture not included in this copy


I took a grinder and cut below the threads.
Picture not included in this copyPicture not included in this copy


Then, I drilled out and slotted the Toyota 12mm adapter that came with the knob to be a snug fit onto the shaft.
Picture not included in this copyPicture not included in this copy


You screw on the shift knob (which takes A LOT of effort and blisters, trust me. It's a VERY snug fit.)
Picture not included in this copy

(To use the stock shift knob, you have to drill it out to be a really tight fit, and hammer it on with a rubber mallet.)

And you're done. It's pretty simple, and the end product is a short shifter that you didn't have to pay any money for. I also have this coupled with an engine-bay short throw kit. 🎉

Replies 7

KioshiFremont, CA · Feb 15, 2009#2
nice economic diy. I'm just scared to grind mines off, but i do want a short shifter like yours, easier on the hills for me here in the city.
33OHThread starterDover, Ohio · Feb 15, 2009#3
I just figured I could always re-weld whatever I grinded off. Then it wasn't as scary. 😆
PRYARISSSPuerto Rico · Feb 24, 2009#4
can you 🆘 me, where I can find the engine-bay short throw kit.
some pics would gonna 🆘

thanks.
spookzSydney, Australia · Feb 24, 2009#5
That would be the NST short shifter.. =)
33OHThread starterDover, Ohio · Feb 24, 2009#6
Originally Posted by PRYARISSS ↑
can you 🆘 me, where I can find the engine-bay short throw kit.
some pics would gonna 🆘

thanks.
NST short shifter or TRD short shifter, the NST one is cheaper and they both do the same thing, plus the NST one comes in different colors. 👍

Here is a link to the NST short shifter: http://shop.microimageonline.com/pro...=1&productId=3
id3379Feb 24, 2009#7
good idea, duno if i'll be grinding mine though :\
33OHThread starterDover, Ohio · Feb 24, 2009#8
I just figured I could always weld it if I messed it up. Or buy a new shifter shaft.