Yarisworld Archive

Rear Sway Bar Instructions - Additional Pics

11 posts · 15,546 views

SeaYaOriginal postPA, USA · Feb 11, 2009#1
Finally got the rear sway bar and had some updated pictures to add some detail to the current install instructions (like the PDF posted on sparks) just to help any first timers.


Step 3(b). “Leave one bolt in place.” & Step 4(a) "Hang sway bar off of shock bolt". I chose to leave the rear-right bolt in place, just because that is the muffler side (may get in the way of larger wrenches, eps. if you are working on the ground and can only do 1/8 turns).

Picture not included in this copy



Step 3(b). “Back the other bolt out until flush with the shock mount.” I left 3 threads (just didn’t want it to pop out) and could still fit the bar over.


Picture not included in this copy

If you’re holding off on doing this yourself because it may be hard or tricky, it takes more time and effort to jack the car and get the tires on and off than putting the actual bar on, that’s how simple it is.

You might want to wait until the part actually shows up before taking your wheels off though. I was too excited! 😁 Longest 19 minute wait of my life!

Picture not included in this copy



Performance Review:

I no longer lean my head and torso into a hard turn. Slow speed or gradual turns will not show the effect of reduced understeer, however, the anti-roll becomes very pronounced at higher speeds / sharper turns, almost as if once you reach a certian cornering force, you can feel the car carving into the turn more than before. The only data I can produce is being able to take 10-20mph turns about 3-5 mph faster, and being able to take 30-35mph turns about 7mph faster.

This was a gateway mod, which enabled me to feel the 'softness' of the front springs....next mod planned.😈


Pros: Easy Install, sharp performance.

Cons: If I hit a large pothole or bump with just one of the rear tires, I can feel it twisting the back end more (bar induces roll from one tire bump). Solution: Don't hit the bumps if possible. Move to state / country with better roads.

Replies 10

Danish YarisCopenhagen, Denmark · Feb 11, 2009#2
Hi

Good pictures and DIY, it looks very easy to install.

Regards Steven.
tristanOrlando, FL · Feb 11, 2009#3
Thanks for this! My TRD sway bar and springs should be coming this week and I'm going to attempt to install them myself so every diy helps
TamagoOff Grid · Feb 11, 2009#4
that's a really cool setup :D ours bolt to the "bottom" of the axle (xA, xB, yaris)
SeaYaThread starterPA, USA · Feb 11, 2009#5
Proof of just how hot this whole setup is....Delivered at 4:01....and right about the time of the test drive...record high temperature in Detroit...coincidence, BAH! 😛


Picture not included in this copy
supmetSouthern California · Feb 11, 2009#6
Originally Posted by SeaYa ↑
Step 3(b). “Back the other bolt out until flush with the shock mount.” I left 3 threads (just didn’t want it to pop out) and could still fit the bar over.
I did the same thing when I installed mine, and it fit perfectly, just like you said. I think this is a good point, since that bolt slipping out could turn a 5 minute install into a long, long day.

Agree with your review too, although I haven't hit any pot holes yet :P
1nzBrunei · Feb 21, 2009#7
Ultra Racing 19mm
Picture not included in this copy
Picture not included in this copyPicture not included in this copy
Picture not included in this copyPicture not included in this copy
Over40Depok - Indonesia · Feb 22, 2009#8
1nz: tein coilovers kah? Not enough that u hv to get UltraRacing rear brace?

so tell me how is d handling of ur vios now?

[interesting! I'm planning to do so myself but just seeking justification from others who does ...]😉
1nzBrunei · Feb 26, 2009#9
yup, the tein basic coilover are good but for very hard driving. eg. small roads and winding corners they are too soft esp at the back because they are not fully adjustable like the super compact

After installing the anti roll bar the handling improved, i can go faster in the corners and now the rear feels stiff
Over40Depok - Indonesia · Feb 26, 2009#10
Originally Posted by 1nz ↑
yup, the tein basic coilover are good but for very hard driving. eg. small roads and winding corners they are too soft esp at the back because they are not fully adjustable like the super compact

After installing the anti roll bar the handling improved, i can go faster in the corners and now the rear feels stiff
Tks Man!
MUSKOKA800Chatham, Ontario, Canada · Feb 26, 2009#11
Originally Posted by tristan ↑
Thanks for this! My TRD sway bar and springs should be coming this week and I'm going to attempt to install them myself so every diy helps
Put the rear springs in first, then add the sway-bar. I learned the hard way.