Yarisworld Archive

Do you feel ur Yaris shaking when waiting at red light?

58 posts · 35,477 views · page 2 of 2

Replies continued

Jcp123E. Tx · Dec 6, 2014#51
Originally Posted by XYaris ↑
Having a tach installed helped me to immediately understand what the shaking is and that it is not a real issue.

When I idle at a light, in nuetral (5sp) but Im not pressing on the brakes the engine will be idling @ ~1000rpm. When I apply the brakes the rpms drop down to say 700 or so, causing a definite vibration. If I let up on brakes, the revs go slightly higher and the shaking goes away. The power brakes are parasitic to such a point on this engine that you can feel the engine adjust to running them. I could see this being a more continual feeling if you drive a automatic.

Anyway, this is the only vibration I have noticed in the car. Im not sure if thats what your referencing. The phenomenon I described seems totally normal and harmless to me.
It's not the brakes themselves, your engine is pumping that vacuum either way. It's the brake lights. I can feel the same thing running wipers, headlights, rear defrost, etc. that energy has to come from somewhere...
sang pengembarajeddah - saudia arabia · Dec 27, 2014#52
Hello there,
I wana share the experience with Y-07 sedan.
1. Vibration during idling
2. More Vibration when AC is on
3. Vibration are common in all gear position P/N/D/3/2/L
4. Noisy vibration is entering the cabin...

I do solved these problem by replacing the Engine and transmission mount (total are 3 pieces ).. Now My Yaris-07 is nice to drive. no more vibration and noisy cabin ... .. I hope the tips will be useful.
CueBallUtah · Dec 29, 2014#53
09 MT LB Mine does sometines..
I dont believe this is 'normal', as some have stated theirs does NOT do it.
My experience is the same as XYaris'. Most noticeable after a freeway run when stopped at the offramp, in neutral, brake lights on. RPM does a little dance.. about 550 then dips to 450 for a sec or two, shakes, then back to 550, then back to 450.. up and down til I change something. Very annoying, feels like it's gonna die.. it would be fine if it would just hold 550 RPM.
I will be looking at the motor and trans mounts for possible wear/breakage.
If it were just an ECM flash, like some say, I would gladly give up the miniscule amout of fuel it would take to keep it running smooth..
I was thinking I might have some carbon buildup in the idle control valve (or whatever controls idle ???) and maybe I do.. Any tips on where/what controls the idle - and how to clean it??? 🤷
esse10richmond TX. · Jan 13, 2015#54
I hate to bring up this old thread but was wondering if anybody has come up with a solution to this RPM Idle being too low and fluctuating up and down causing the motor to vibrating as if it's gonna stop? I think that motor vibration at Idle will cause wear & Tear on your engine Mounts.
mr_robotNYC · May 29, 2018#55
Originally Posted by CueBall ↑
09 MT LB Mine does sometines..
I dont believe this is 'normal', as some have stated theirs does NOT do it.
My experience is the same as XYaris'. Most noticeable after a freeway run when stopped at the offramp, in neutral, brake lights on. RPM does a little dance.. about 550 then dips to 450 for a sec or two, shakes, then back to 550, then back to 450.. up and down til I change something. Very annoying, feels like it's gonna die.. it would be fine if it would just hold 550 RPM.
I will be looking at the motor and trans mounts for possible wear/breakage.
If it were just an ECM flash, like some say, I would gladly give up the miniscule amout of fuel it would take to keep it running smooth..
I was thinking I might have some carbon buildup in the idle control valve (or whatever controls idle ???) and maybe I do.. Any tips on where/what controls the idle - and how to clean it??? 🤷
Did you ever find the idle control valve? Where is it on this car? Bought a gasket for it to replace it when I clean it but seems like it's part of the TB?
bobthesilentBurnaby, BC · Jan 7, 2019#56
Originally Posted by esse10 ↑
I hate to bring up this old thread but was wondering if anybody has come up with a solution to this RPM Idle being too low and fluctuating up and down causing the motor to vibrating as if it's gonna stop? I think that motor vibration at Idle will cause wear & Tear on your engine Mounts.

as long as the RPM stays around 500 to 550, it will not stall. I have found that TURNING OFF the defroster when you dont need it is the best way to fix the problem as it uses the AC condenser and the extra load causes the momentary dip in RPM. Wiper blades will do it too. It seems to be a normal function of the small engine.
bairjoJan 7, 2019#57
Put it in neutral while you are at the light...vibration should go away.
rayfloyd170SAUDI ARABIA · Feb 6, 2019#58
I experienced this, the mechanic dismantled the Throttle Body and cleaned it. Put it back and everything went back to normal.. A lot of dirt accumulated in the plates and the sides of the airway of the TB.

Once in a while TB needs to get cleaned, for desert people, it is required often. I used original engine air filters from toyota and i normally blow them every 10kkm during change oil,,, however i replaced them every after 20-30k km just to be sure they are still efficient in filtering dusts...