Yarisworld Archive

Looking for guages for basic 3 dr. hatchback

8 posts · 4,896 views

rheroOriginal postHolloman AFB NM · Dec 13, 2008#1
Looking for aftermarket tach, voltmeter and water temp. guage. Glow Shift sells 2 1/16" guages but, they suggest installation in a pillar pod. Do not wish to install guages in the pillar because of curtain air bag. Also, do not wish to splice into factory wiring if I don't have to. I've never installed guages in a car before. Any suggestions concerning guage install, sensor install and brands would be appreciated.

Replies 7

cali yarisCanoga Park, CA · Dec 14, 2008#2
Autometer is a good brand; I sell them. Glowshift gauges are cheap and inferior.
If you pull your A pillar, you'll see the curtain barely goes into it.
You can safely install gauges further down.

I installed them like this:

Picture not included in this copy

Picture not included in this copy

Picture not included in this copy

Picture not included in this copy
TheRealEnthMiami, FL · Dec 14, 2008#3
Do you sell the Tach one you have?
at3GGVA Beach · Dec 14, 2008#4
I have a sunpro tach. easy enough to install, but you will have to splice into a wire for the rpm readout.

The voltmeter took all of fifteen seconds to install. Just add a fuse, all its needs is power obviously.

P.S No longer have my voltmeter installed, just didnt like the way it looked.
cali yarisCanoga Park, CA · Dec 14, 2008#5
realenth, I sell all Autometer gauges. The one on my car is Phantom II, which has a white face. PM me if you want a price, I'll have to call for it.
PHXDEMONPhoenix, AZ · Dec 14, 2008#6
Glowshift guages wanted to sponsor me. I told them they can keep that cheap crap because I am not putting one of their vinyls on my car 🤣
RevssonSoutheast Wisconsin · Dec 15, 2008#7
Garm also sells the ScanGaugeII.
http://www.scangauge.com/
http://www.scangauge.com/features/

It just plugs into your OBDII, so no splicing of wires. Do a search for ScanGaugeII
on this site, and you will see lots of info. There is also a DYI for a Tach installation.

Hey Garm, I think the white faced gauges look pretty good. I had thought the black
faced ones might look better. Did you get white faced because the car is white?

I have been thinking about getting the ScanGaugeII from you, but also thinking about
how my white faced one would look. It is the same model as the one in this posting:
DIY: TACH INSTALLATION INSTRUCTIONS
I like that you can still open the driver's side compartment. Any problems
opening your's with the oil pressure gauge line?

Below are sanityassassinv2 tach install pics.

Picture not included in this copy
Picture not included in this copy
cali yarisCanoga Park, CA · Dec 15, 2008#8
I got white because I like them and I'm doing a white & black thing with my car.

I do sell the Scangauge, but keep in mind it runs off the OBDII so it's not so useful for things like engine rpm's (but fine for other things like temp, mpg, volts, etc.) I have a killer deal running on it right now (but I can't publicly say the price).

My driver's glove box opens fine, I made a nice little harness with loom in there -- all the gauges are full sweep electric. Not much room in there now though!