CKaelinOriginal postBoxborough, MA · Nov 19, 2008#1I loaned my scan guage to a friend with a tacoma. I have not been able to get it recalibrated to my Yaris since I've gotten it back. I think I may have furthered the problem after filling up. I adjusted the % to 100 asssuming that meant the tnak was 100% full. Any advice on how to rest the scan guage?
Thanks in advance!
Replies 4
Bob_VTVermont · Nov 19, 2008#2You have to go through the setup and remember when you FILL the tank you shoud have to do that 2x. It has a flash memory so there is no real reset.... just new setup.
The manual is available on line.
Remember the Yaris Fuel Cut Off should be set to 21
CKaelinThread starterBoxborough, MA · Nov 19, 2008#3 Originally Posted by
Bob_VT ↑ You have to go through the setup and remember when you FILL the tank you shoud have to do that 2x. It has a flash memory so there is no real reset.... just new setup.
The manual is available on line.
Remember the Yaris Fuel Cut Off should be set to 21
I had done the set up: tank size, fuel, engine size etc.. I had not set the Fuel Cut off it was at 0. When I fill up do I have to adjust the percentage shown or should I leave that alone?
Thanks Bob!
Bob_VTVermont · Nov 19, 2008#4Leave the percentage alone and remember to run the tank down about 3/4 after 2 fill ups it should be accurate again.
CKaelinThread starterBoxborough, MA · Nov 20, 2008#5Well I found the magic "reset to defaults" reset button that noone thought exists. Not sure how exactly but I did. Then followed the set up. It's working great once again.. =) I will "refill" today aswell..