Yarisworld Archive

Sedan owners

11 posts · 4,624 views

ShroomsterOriginal postOrlando · Oct 30, 2008#1
I have a question about your instrument cluster dimmer switch.
when you roll it all the way up it gets brighter, then when you pass the "click" at the top does it get fully bright or does it turn off?


I ask because I have seen three different sedans in the rental fleet that do this and I'm not sure if that is what they should be doing or not.


REMEMBER THIS IS FOR THE SEDANS ONLY NOT THE LIFTBACKS


thanks!

Replies 10

RHDVIPbBLouisville, KY · Oct 30, 2008#2
never looked. Will have to try this.

Although my friends tC did this before. Probably due to a load on the electrical circuit.
CrazedEpidemicNew York City · Oct 30, 2008#3
The lights for mine turn off when it clicks
||)) (o) ||\||Southwest PA · Oct 30, 2008#4
Mine turns off and lcd gets brighter.
ShroomsterThread starterOrlando · Oct 30, 2008#5
Originally Posted by CrazedEpidemic ↑
The lights for mine turn off when it clicks
ok thats what I was wanting to find out....This is the first Toyota model I've seen (on the lot) that cuts the power after the click. usually the click makes the rheostat push the highest voltage setting to emit the most light.....meanwhile turning the dial all the way down is supposed to dim the instrument panel display....

weird.....
CrazedEpidemicNew York City · Oct 31, 2008#6
Yea I thought that was weird too, when I push it up it gets brighter until it clicks and just turns off.
id3379Oct 31, 2008#7
After the click,The Tach & Speedo Cluster goes out, and the fuel gadge LCD screen goes super brite
eiiLong Beach, CA · Oct 31, 2008#8
Originally Posted by id3379 ↑
After the click,The Tach & Speedo Cluster goes out, and the fuel gadge LCD screen goes super brite
+1
MUSKOKA800Chatham, Ontario, Canada · Oct 31, 2008#9
I'll have to check that out. I've never needed to turned it up full bright.
HerbicidalRoseville, CA - USA. · Oct 31, 2008#10
Originally Posted by eii ↑
+1
+2
captainm27New Jersey · Nov 2, 2008#11
Well, what happens is this: Because the instrument panel is covered, there are times when it's cloudy and the day is not that bright, so you turn on your headlights, this turns your instrument guage into 'night mode' by dimming the fuel gauge light panel and turning on the light on the guages. However, sometimes I find it that the fuel gauge light is too dim during these times when it's not yet night, but it's not bright outside. So once you pass the click on the dial, it allows you to have your headlights on, but also have your guage on regular mode, not night mode.

I use this very frequently, and then you can tell that you your lights are still on because you will see the little headlight bulb on your dash turn on.