Yarisworld Archive

Need help with Tein spring install...

7 posts · 6,513 views

Smokey159Original postLexington, KY · Oct 28, 2008#1
I bought a set of used Tein S-Tech springs.

I need pics of them installed from the underside.

I need to find out which end is up, and I need to know what the instructions said for the recommended cut is on the bumpstops.

I looked on tein's website, but the install instructions page comes up with "page not found".

Thanks in advance.

Replies 6

largeorangefontSo Cal, OC · Oct 28, 2008#2
Originally Posted by Smokey159 ↑
I bought a set of used Tein S-Tech springs.

I need pics of them installed from the underside.

I need to find out which end is up, and I need to know what the instructions said for the recommended cut is on the bumpstops.

I looked on tein's website, but the install instructions page comes up with "page not found".

Thanks in advance.

Flat side of the springs go to the top,

Cut the bumpstops just below the plastic piece in the center, which is cutting off about an inch.
Smokey159Thread starterLexington, KY · Oct 30, 2008#3
OK, I got the official word from Tein on this issue.

The S-Techs require that 1.4 inches be cut off the end using their "A" cut method. They have 4 different ways to cut bumpstops, the different methods can be found in the tech section of their website.
mojoyarisVancouver · Nov 2, 2008#4
Have fun Modding your car. And yes. I think you really are missing your STI.......
nerd_vitZSan Diego · Nov 4, 2008#5
i just looked at the words on the spring itself. up = up?
Malaya1221Torrance, Ca · Nov 4, 2008#6
^ if you could read the words from the spring then you're installing it correctly!
thewifesyarisReno, NV · Nov 4, 2008#7
A pic of mine from a while ago.
Picture not included in this copy