Yarisworld Archive

Trouble removing stock HU bolts

8 posts 路 4,008 views

The SpectacleOriginal postTampa, FL 路 Oct 24, 2008#1
I've got the stock HU out of the car but I cannot get the brackets off the side because the damn bolts are like siezed on!!!! I tried a regular phillips and a crescent wrench and I could not get them off. I have a socket set but it looks like the bolts are 8mm and the smallest I have are 9mm馃憥

Anyone else experience anything like this before during their install?

Replies 7

bdc87Lake County, CA 路 Oct 24, 2008#2
Nope, screwdriver worked for me, you might have to pickup an 8mm.
TinyGiantRochester, NH 路 Oct 24, 2008#3
screw driver worked for me too... you might try tapping the screw driver with a hammer lightly a few times to kinda free it up. or have someone tap the back of the screw driver while you turn it .. kinda like an impact wrench... tap lightly! not hard
sportin83central IL 路 Oct 24, 2008#4
get a 8mm makes it super easy. they must torque them in, there really is no need for them to be this tight.
talnlnkySpokane, Wa 路 Oct 25, 2008#5
yeah... normal screwdriver worked for me too.
The SpectacleThread starterTampa, FL 路 Oct 25, 2008#6
Had to use a 8mm socket to get them out. What a bitch!
talnlnkySpokane, Wa 路 Oct 28, 2008#7
hmmm....i only had 4 screws.... I wonder if the integrated units are all a pain to remove...and if the non-integrated units are easy to remove?
battleversiontc808 路 Oct 28, 2008#8
the integrated one was easy 4 bolts pops right out