Yarisworld Archive

Am I taking the transmission out again?

5 posts · 3,310 views

TiedBassDrummerOriginal postSun Valley, NV · May 15, 2022#1
I recently replaced the clutch for my Yaris. Along with the flywheel and pressure plate. Before I started bolting more things back together I figured I should test to make sure that neutral was neutral, and discovered what is seen in the video.

https://youtube.com/shorts/LyJIz_jwhSs
At 8 seconds I press the clutch pedal in.
At 13 seconds I release the pedal.

I am 95% sure this means I need to take the transmission out again, but I would like someone more knowledgeable than I am, cause I'm sure not, to weigh in.

Replies 4

ex-x-fireSheboygan Falls, Wi. · May 16, 2022#2
No, that's normal when the tranny fluid is cold. For some reason the spinning main shaft cause the fluid to whip up and make the other shaft turn a bit. Put the wheels on and you'll see that you can stop it easily by hand.
remcafeeArizona · May 16, 2022#3
did you install a lightened flywheel? im thinking about doing one and trying to seenif anyone here had one so i can get some input
TiedBassDrummerThread starterSun Valley, NV · May 16, 2022#4
Thank you ex-x-fire. I did notice that it was easy to stop by hand when I had a tire on.

remcafee - I did not install a lightened flywheel. I put an OE flywheel in. I know I have come across old posts about lightened flywheels on the forum though.
ex-x-fireSheboygan Falls, Wi. · May 16, 2022#5
If it's a daily driver I wouldn't use a light flywheel.