Getting misfires on cylinder 1( started a thread on that). Wanted to look at plug . Here’s some pics and tips.
Changing out a plug in 2007 Yaris sedan
9 posts · 3,575 views
Replies 8
Thexton 492 spark plug starter . Old plug boot or rubber hose works too. If plug is cross threaded hose will slip

Plug threaded in

I then bottom it with extension /spark plug socket. I have a 1/4 adapter for 1/4 torque wrench. I spin up and down to make sure plug moves freely and no cross thread. It will feel gritty because of carbon deposits on threads in spark plug hole.

Torque spec is 13 lb ft or 156 inch lbs. I set wrench to 170. I’d rather err slightly tighter than looser. 1/2 turn seated plug gaskets. I actually loosened again and spun plug up and down to again checking for cross thread.. Torqued again this time 1/4 turn til click because gasket on plug was crushed. If the plugs been in a awhile sometimes a 1/8 turn will click.

Super lube dielectric grease in coil . A dab put in top of boot.

Torquing coil 10mm bolt to 80 inch lbs.

Torquing cover 10mm bolts to 80 inch lbs

And if you loose the insert washer on top of cover a 7/8 washer fits