Yarisworld Archive

Yaris 2008 ALL tail/brake lights not working, replaced fuse and bulb already

6 posts · 8,625 views

mrgodaiOriginal postUnited States · Feb 6, 2019#1
USA Yaris 2008 Sedan.

So it starts off with passenger tail/break light not working at all.

I replaced the bulbs in both of them and still off. I put it off for a month. Now I went to check, ALL the brake/tail light are not working! even the high one by the window. I checked and replaced TAIL and PANEL1 fuses and still no go.

From what I read it's probably a wiring problem.

How do I use a multi-meter to check? and is there a guide for where the wires are and what panels I need to take off to check them?

Thanks in advance.

Replies 5

tmontagueCaledonia Ont. · Feb 6, 2019#2
Set your multi meter to DC volts then find your wire loom that goes to the lights that are not working. Simplest way is to start at the lights and work back. You will eventually fine that they all merge into one loom. There should be connectors along the way, disconnect them and ground your negative lead to the body if the car that you know is s good ground. Then take your red lead and test the pins in the connector and you should fine one is 12v when its given its signal (ie: brakes applied or 4 ways put on).

When you get to the first point where there is no power, look at the wiring or the connectors and you will likely find the issue. This is a simple way if you dont have wiring diagrams, but it is not as accurate
SirDigbyDenver, Colorado · Feb 21, 2019#3
i'm guessing it's the brake switch. or wiring to the brake switch. they are thin wires.
dogsridewithUSAnotCA · Feb 22, 2019#4
Do any of the lights on the rear end of the car work?
bob225Kent,UK · Feb 22, 2019#5
Brake lights are a very simple circuit do your sidelights, 4 ways and directionals work ?

If so i would throw a brake light switch at it
dogsridewithUSAnotCA · Feb 22, 2019#6
OP said tail lights also not working.