Yarisworld Archive

Mil-Spec Engine Harness

15 posts · 9,743 views

ArmstrongRacingOriginal postSan Diego · Nov 6, 2018#1
I've had plans to have a RyWire style harness for a long time, but no one wants to build one for any of us without a 2JZ...

My solution = build one myself.

I had a spare 2ZR harness laying around that came with my engine from the junkyard, but it was damaged in the accident.

Step 1 - I stripped it down, labeled it all, and formed a plan of how to route it cleaner.Picture not included in this copy

Replies 14

ArmstrongRacingThread starterSan Diego · Nov 6, 2018#2
The routing plan.

Now, of course, I will need to have sub-sections branching out from the main loom. I'll try to keep it super clean along the way.

Picture not included in this copy
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#3
Now thanks to Cranky I have plenty of this recycled braided loom, so I'll start doing the loom in sections where there are groups of connections. You can also see the mil-spec circular connector in the center, this is for a quick twist disconnect of the whole drivetrain from the car. (I'll need another plan for the starter and alternator cables).

I started with the coils, heat-shrink the end shut where cylinder 1 is, measure the distance between each plug and cut slots in the loom to feed the wires through. Tape that up with the yellow electrical tape.

Next was the injectors, followed by the crank sensor and VVT OCV's.

Picture not included in this copy
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#4
Reserved for harness - alternator, knock sensor, throttle body
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#5
reserved for harness - cam sensors, A/F sensor, coolant temp & MAF sensor
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#6
Reserved for harness - HES connector location and chassis side routing
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#7
reserved for harness - assemble connector
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#8
Reserved for harness - starter cable
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#9
reserved for harness - alternator cable
ArmstrongRacingThread starterSan Diego · Nov 6, 2018#10
reserved for harness - testing
saikouguySydney, Australia · Nov 7, 2018#11
Impressive stuff. Will be following this 👍
CrankyOldManWest Michigan · Nov 8, 2018#12
I swear I'm not a hoarder, if only because I sometimes get rid of stuff. =)
LeegamerAshland, VA · Nov 8, 2018#13
This is awesome. Are you using a stock ecu or standalone?
ArmstrongRacingThread starterSan Diego · Nov 8, 2018#14
Stock ECM so anyone can use it. And with the HES connector the harness is expandable to be used with any standalone or piggyback controller.
atomic_hojiKincardine, ON, Canada · Nov 8, 2018#15
Sub'd! Looking forward to seeing this come together. Thanks for the great work as always, Tom! 👍

-- Adam