so my latest symptom has been a loud humming under load at 3-4k rpm, its very obvious/annoying on the highway, related symptoms is vibration of the clutch pedal at all times. what does anyone think this could be? a transmission specialist down the road sounded confident that the motor mounts were placed back incorrectly, and ive also read online about the possibility of input/ output shaft misaligment. my initial issue of a chirping clutch fork was solved with lithium grease but i feel like the throwout bearing is vibrating more than it should to begin with (after the replacement), any ideas? f*** this is so heartbreaking i love my car 😢, if anyone experienced could chime in it'd be much appreciated!
driveline noise after clutc/flywheel install
2 posts · 12,779 views
Replies 1
It's going to be really hard to say without either as much info as possible and/or disassembling the trans from the engine.
If the clutch pressure plate wasn't perfectly centered on install it could cause the symptoms you're experiencing.
The engine/trans mounts would be the cheapest and easiest to check so start with that
If the clutch pressure plate wasn't perfectly centered on install it could cause the symptoms you're experiencing.
The engine/trans mounts would be the cheapest and easiest to check so start with that