I just installed an aftermarket HID kit, but the beam is aiming too high, please if anyone know there's anything I can do the aim the beam lower?
How to adjust the angle HID
9 posts · 4,035 views
Replies 8
You'll find white nylon adjusters behind the headlamp housing, just to the inside of the bulb on each side. Use a phillips head screwdriver.
You might want to count how many quarter turns from factory you go and record that somewhere so you can go back to factory settings in the future.
You might want to count how many quarter turns from factory you go and record that somewhere so you can go back to factory settings in the future.
Picture not included in this copy
i don't know if pointing them down will help. the beam pattern sucks with these housings. i still get a lot of glare with them pointed all the way down to the point where it is almost unsafe to drive at high speeds on the freeway. i'm thinking about removing mine. good luck!
thanx, I will try adjusting first👍
I implore everyone to not install HID retrofits without using a projector housing. It is dangerous and annoying to other drivers in front of you.
http://www.danielsternlighting.com/t...nversions.html
http://www.danielsternlighting.com/t...nversions.html
I agree, but you're fighting a losing battle.
LOL I know it. It can't hurt to spread the word though.
Absolutely. HID in reflector housings blind other drivers, and are unsafe.
That said, I've seen some pretty good results from aftermarket HIDs in OEM projector housings (where the OEM uses the same projector housing for their Halogens and HIDs).
That said, I've seen some pretty good results from aftermarket HIDs in OEM projector housings (where the OEM uses the same projector housing for their Halogens and HIDs).