Yarisworld Archive

Serpentine Belt Replacement - Is it possible to get it too tight?

6 posts · 6,580 views

keith204Original postBolivar · May 19, 2015#1
I'm about to replace the serpentine belt on my 2007 Yaris. From reading around on here, I see that if it squeals, it's too loose. However, would a belt that's too tight put bad pressure on the pulleys?

Since nobody seems to be mentioning a too-tight belt, I'm thinking that it's probably difficult to get it too tight.

Thoughts?

Replies 5

CrankyOldManWest Michigan · May 19, 2015#2
Yes. Over-tightening the belt can/will cause premature failure of one or more bearings, usually the water pump or alternator. Welcome to the World!
bail_wBay Area, CA · May 19, 2015#3
The rule of thumb with serpentine belts is to try to twist the belt 90 degrees in the middle of the longest span - it should twist 90 degrees but no more.
bronsinnj · May 19, 2015#4
Yes thats what Ive heard the 90 degree twist thing.

Which makes no sense to me because no matter how tight the belt is you can twist it 90 degrees!

I guess what I would do is tighten it so it squeeks. Then a little more. More. More. Until it stops. Then back it off a hair.

What could it hurt if it squeeks? 🤷
tmontagueCaledonia Ont. · May 19, 2015#5
I tighten it so that it is very firm when pushed down in the middle of the longest span. I allow it to move a cm or so either way w/ quite a bit of force pushing on it.
eseibel67Canada · May 25, 2015#6
You can make it good and tight without damaging bearings. When it spins, the belt is looser than when it's standing still.