DIY yaris III fog lights installation
55 posts · 117,165 views · page 2 of 2
Replies continued
Hi
Everything installed and it worked fine for few minutes. then even the dashboard light went off. Fog light is not coming on. Any help is appreciated.
Thanks
Edit: Solved
Sent from my SM-G935F using Tapatalk
Everything installed and it worked fine for few minutes. then even the dashboard light went off. Fog light is not coming on. Any help is appreciated.
Thanks
Edit: Solved
Sent from my SM-G935F using Tapatalk
After installing fog light the fuse is always blowing. Will last only for few minutes. Any help. Thanks.
Sent from my SM-G935F using Tapatalk
Sent from my SM-G935F using Tapatalk
Hi everyone,
I’m currently adding fog lights to my 2016 Canadian Yaris Hatchback (LHD). The car is pre-wired (I’ve found the plugs behind the bumper and the FOG FR fuse is present in the interior panel).
I want to use the factory wiring to keep the installation clean, but I have a specific request: I do not want to replace the steering column stalk (arm). I prefer to relocate the fog light switch to one of the empty slots in the dash, next to the mirror controls.
My situation:
I’ve identified two small connectors near the steering column (one with green wires, one with black wires), but they are too short to reach the dash.
I know I need to install the relay in the "hidden" location behind the Junction Block/Body ECU.
My questions for the experts:
Which specific wire on the steering column harness should I tap into to trigger the factory relay?
If I bridge this wire to a ground through a dash switch, will the factory circuit work (provided the low beams are on)?
Does anyone have the pinout or wire colors for the headlight stalk connector on a 2016 Canadian model to make sure I trigger the right signal?
I’m trying to avoid pulling the steering wheel and changing the stalk while still utilizing the pre-installed harness for the lights themselves.
Any help or wiring diagrams would be greatly appreciated!
I’m currently adding fog lights to my 2016 Canadian Yaris Hatchback (LHD). The car is pre-wired (I’ve found the plugs behind the bumper and the FOG FR fuse is present in the interior panel).
I want to use the factory wiring to keep the installation clean, but I have a specific request: I do not want to replace the steering column stalk (arm). I prefer to relocate the fog light switch to one of the empty slots in the dash, next to the mirror controls.
My situation:
I’ve identified two small connectors near the steering column (one with green wires, one with black wires), but they are too short to reach the dash.
I know I need to install the relay in the "hidden" location behind the Junction Block/Body ECU.
My questions for the experts:
Which specific wire on the steering column harness should I tap into to trigger the factory relay?
If I bridge this wire to a ground through a dash switch, will the factory circuit work (provided the low beams are on)?
Does anyone have the pinout or wire colors for the headlight stalk connector on a 2016 Canadian model to make sure I trigger the right signal?
I’m trying to avoid pulling the steering wheel and changing the stalk while still utilizing the pre-installed harness for the lights themselves.
Any help or wiring diagrams would be greatly appreciated!