fnkngrvOriginal postIn The Hotbox · May 3, 2014#1I will be reverting to my stock pulley due to higher rpm ceiling. I will have the NST pulley off in a couple days. I will ship to the lower 48 for $70. The rest of North America or overseas will require us to figure it out.
Picture not included in this copy
Replies 5
bebeeloStockton, CA · May 4, 2014#2is that bad for you to have high rpm ceiling?
fnkngrvThread starterIn The Hotbox · May 4, 2014#3The underdrive pulley was designed to work with stock tolerance and rev limit. According to NST taking it even up to 7k is supported. I will have a rev limit over 8 most likely with high power output so just makes sense to go to a beefier pulley hence the reuse of the stock part. This NST pulley has been great for me and I have no complaints. To be honest if it wasn't such a bear to change I would use it during DD and just swap for my speed runs. I can't really think of a reason to need to take the engine past 7k on the street.
sent from my m-o-b-i-l-e
fnkngrvThread starterIn The Hotbox · May 5, 2014#4Bump
fnkngrvThread starterIn The Hotbox · May 7, 2014#5Pending!
fnkngrvThread starterIn The Hotbox · May 7, 2014#6SOLD!
Please close and thanks!