Yarisworld Archive

Vitz 2sz-fe air intake?

6 posts · 10,265 views

blackvitzOriginal postMalta · Feb 11, 2014#1
Anyone can give some tips if a custom air intake can be done for a vitz 1.3 2s-fe 2006 ? if yes any problems with maf sensor? K&N and other brands never produced something, so I was thinking of doing a custom one. So far i have a cone filter attached to the plastic box but i wish to make a stainless steel pipe attached to the throttle body so I can improve performance and sound. opinions appriciated. Thanks!

Replies 5

WeeYariGeorgetown, Ontario, Canada · Feb 11, 2014#2
Use aluminum, not stainless steel for the pipe.

You should have no issues custom fabricating just as long as you keep the inside diameter of the pipe the same as OEM. Use of a different diameter piping almost always with throw a code.

Is this what your engine looks like?

Picture not included in this copy

or this?

Picture not included in this copy
blackvitzThread starterMalta · Feb 11, 2014#3
my engine is the first picture. Japanese and european yaris are like that.
ExiwolfmanWasaga beach · Feb 11, 2014#4
I would not be surprised if one could not use honda civic intakes cos they run of the back and top ..its the sensor that u hqve to worry about its placement.... pvc pipes from a hardware store work good too most are heat resistant and dont hold heat like aluminum so more cooler air gets in.
japleKuala Lumpur, Malaysia · Feb 11, 2014#5
honestly, i rather just throw in a drop-in filter and move on, reason is that the original piping is a cold air intake by itself, jusdging from the pic, correct me if i am wrong, unlike the 2007 vitz, which is just a loop, not connected to the cold air outside...
blackvitzThread starterMalta · Feb 12, 2014#6
what I have right now is a cone filter attached. I removed the pipe and attached the filter to the box I removed also the stock one from the box. its ok but it is not attaced direct to throttle body, so I can gain more power I think.