yaris1F8Original postCanada · Aug 14, 2013#1Anyone here can help out.. i was torquing a screw holding the cowl cover right at the strut, and i dropped my 10 mm short wrench in the fender.. damn..I felt it go all the way down..haha.. I tried with a magnet but to no avail.. the thing is when im driving i dont hear it banging around, sounds like its wedged.. Does this mean i need to remove the wheel well cover.. anyways can someone help out.. lol
🙄🙄
Replies 5
CTScottUSA, CT · Aug 14, 2013#2I would say that it is likely wedged between the fender liner and the fender. You can release a couple of the clips on the wheel arch to get a peek in.
yaris1F8Thread starterCanada · Aug 14, 2013#3Hi CTScott i did that and i push my magnet in there moved it around.. no catch.. im guessing i will need to remove the wheel well.. is this a big job ? Damn.. not being to lucky these past couple weeks. Btw the popping noise i was hearing was the cowl cover, has a busted screw.. I had to drill and retap.. put in a new screw.. no more noise. :)
CTScottUSA, CT · Aug 14, 2013#4If by wheel well, you mean the whole fender, then it is a bit of a hassle. I would start with just freeing the fender liner, as that will give you full visibility under the fender.
yaris1F8Thread starterCanada · Aug 15, 2013#5I meant the inside of the fender.. the black plastic covering.. i bought all new clips, i figured some might break off so.. Now i need the time to do this, its looking good for friday morning. (y).. I hope i find the 10 mm
CTScottUSA, CT · Dec 1, 2013#6 Originally Posted by CB Spoolmak ↑
I am guessing that removing the front wheel first before the fender liner would facilitate ease of access/egress? I am following the hood release cable & it hides behind the driver side wheel well liner.
Yes. Removing the wheel gives you far better access.