Yarisworld Archive

My new grille blocks for my sedan...

13 posts · 4,367 views

malibuguyOriginal postWestminster, MD · Feb 7, 2013#1
Picture not included in this copy

Replies 12

fnkngrvIn The Hotbox · Feb 7, 2013#2
reason for using?
Bluevitz-rsOshawa, Ontario, Canada · Feb 7, 2013#3
Nice! Can hardly tell it's there.

fnkngrv, it makes winter/cold weather driving much better. Much shorter warm up times, and protects the rad from salt and stones.
fnkngrvIn The Hotbox · Feb 7, 2013#4
so wtb then? 🎉
malibuguyThread starterWestminster, MD · Feb 7, 2013#5
Yes faster warmup and less aero drag from the air being slowed down going thru the rad. I normally would of ran a smaller opening but I figure this will work for now. My old xB my left over opening was about half of this.
yarisugiハワイ · Feb 7, 2013#6
Looks great! I'm curious about engine temps. Blocking off both top and bottom inlets, does it ever get too hot? (overheat)
Bluevitz-rsOshawa, Ontario, Canada · Feb 7, 2013#7
I run the lower completely blocked off and I never run into issue until about 5°C above freezing.

I have a mechanical temp gauge in the block, so I know the exact water temp. Normal with no block it runs at about 180-190°F. With the block it runs 190-210 on the hwy. But that's only after about 20-30min. If it gets any hotter I just turn the heater on and crack the windows and the temps come down.
malibuguyThread starterWestminster, MD · Feb 7, 2013#8
i havent hooked up my scangauge to verify temps yet. but i figured my xB was fine even during the summer with a smaller opening, then mine should be fine...especially now

i probably should actually install the scangauge in this car...
BEEFnorth carolina · Feb 8, 2013#9
I've been running a full grill block in my cavalier for around 4 years now. I know, different car, different challenges. I started with the plexiglass cover though I will say it gets pretty scuffed over time. I painted my cover and did that for a while until I fiberglassed it off. the end product came out pretty well though youtube flamed me pretty hard over it.

Depending on how the car gets its cooling, blocking off the grill doesn't matter at all. My cavalier actually got 90% of its cooling from underneath. Not sure how the airflow in the yaris works yet.

It does look good and very incognito
malibuguyThread starterWestminster, MD · Feb 8, 2013#10
Its got a factory tray under the bumper. So its sourcing all the cooling air from up front
Hersheynortheast · Feb 8, 2013#11
Very nice . 👏
dragoonmcIllinois · Feb 24, 2013#12
I did a very similar thing except I used black aluminum which means it just looks like one big hole to me
STCState College, PA, USA · Feb 26, 2013#13
Nice! Aesthetically appealing!

Cheers! 🙂