Yarisworld Archive

Pulley Squeak

11 posts · 3,440 views

skootdogOriginal postBaton Rouge,La · May 26, 2012#1
I just put in a new pulley from micro image and now the belt is squeaking against it. Makes my engine sound like Donkey! Solution anyone?

Replies 10

GolddeenohColumbia, SC · May 26, 2012#2
did you check and make sure that the alternator was pulled back to it's original position and did you make sure that it is aligned correctly. If it is a little off it could make some noise on when the belt rubs the A/C compressor.
ViozLong Island, NY · May 26, 2012#3
Just take the bar to change your tire with and wedge it between the alternator and mount and pull back on it while tightening the bolt on the alternator to lock it in place, did so with mine and it stopped the squeaking. Also make sure your belt isn't damaged, didn't notice mine was damaged and it completely snapped while I was driving and my engine overheated :)
skootdogThread starterBaton Rouge,La · May 27, 2012#4
I had put a mark on the alternator and the bracket before i loosened it to take it off. The belt still looks ok from what i can see. It starts to make it once the engine get warm.
cali yarisCanoga Park, CA · May 27, 2012#5
You should re-tension the belt, regardless of where your mark was.
eTiMaGoBangkok, Thailand · May 27, 2012#6
and do not under any circumstances spray anti-squeal in there... I had a squeaking problem too, thought it was already too tight so tried that stuff, and well... belt disintegrated not too long after...
GolddeenohColumbia, SC · May 27, 2012#7
^ well it quit squealing once it wasn't there anymore🤣
skootdogThread starterBaton Rouge,La · May 27, 2012#8
😆Haha. Thats one way to fix it! Ill try tightening a bit more a see. I pulled on it and it seemed really tight, almost to tight if you ask me🤷 Thanks!
skootdogThread starterBaton Rouge,La · May 28, 2012#9
Ok, so I tightened it. It pulled about a half inch or so but it still squeaking. I dont have any way of checking the tension but i know its snug now. Anymore suggestions? WD40...A new kinda belt, Haha. I think when I get home tomorrow Im going to take it off and have another look. 🤷
cali yarisCanoga Park, CA · May 28, 2012#10
Was the pulley 100% installed correctly? Torqued to 95 ft/lbs.? Just checking. 🙂
skootdogThread starterBaton Rouge,La · May 29, 2012#11
Yep, went and bought a torque wrench just for it. I listened today when my lady got home from work. I think it may have stopped. I'll have to get back to it when i can. Thanks