Yarisworld Archive

Nitto midpipe

5 posts · 4,594 views

carlo0616Original postSwansea · Jan 2, 2012#1
Hi was going to get a custom mid section made up but found the nitto one on microimage. I'm wondering if it will fit the 1.8?
Obviously the bends and hangers will fit the same also Im sure the rear flange is the same, I think I will have to modify the header flange?
Also how many sensors are in our exhaust and will they wit in this

Thanks

Replies 4

Klink10910 · Jan 3, 2012#2
Don't know about fitment. Just 1 sensor in the Nitto which will need a anti-fouler to keep from getting a code. Other sensor is in the header.
CrankyOldManWest Michigan · Jan 3, 2012#3
I'm curious about this too. I've been looking at the feasibility of a N.American hatch to T-sport conversion (1.8L, 6-speed) and ended up with the same general question. The T-sport mid-pipe is exclusive to the T-sport (from toyodiy.com) but I can't say if it's due to emissions or fitment.
cali yarisCanoga Park, CA · Jan 3, 2012#4
This will depend on the header being positioned in the same position and angle as the 1.5L header. I'm not sure, but I could look at an xD header next to a Yaris header and check that out.
bzinn 1University Place,WA · Jan 7, 2012#5
I looked at a xD header and midpipe and it looks close but not a perfect match up.....but that is also from under a car and not a side by side angle matchup......think we will need Garm to do a side by side.