Yarisworld Archive

putting in a new system

11 posts · 4,026 views

ttr125fan09Original postcorpus christi, texas · Sep 1, 2011#1
i have a question though, if i run my sub of an amp, will my door speakers still be able to be powered from the head unit, im a newb at this....

Replies 10

sqcompBack at home · Sep 1, 2011#2
The short answer is yes.

Question for you:

What have you purchased so far for the system?
ttr125fan09Thread startercorpus christi, texas · Sep 1, 2011#3
The Subwoofer

The amp for the sub

And the door speakers

its nothing fancy, just better, if you have any tips or input, please fill me in
sqcompBack at home · Sep 1, 2011#4
What's the source? Stock?
ttr125fan09Thread startercorpus christi, texas · Sep 1, 2011#5
if your talking about the headunit, its a kenwood, ill try to find out what model
Lil AbnerDublin, Ohio · Sep 1, 2011#6
Chances are the Kenwood will have an RCA pre-out for the subwoofer. If so, then just hook your amp to that output with a set of RCAs and you'll be golden.
BEEFnorth carolina · Sep 2, 2011#7
just spend some money on the RCA cables and don't run them right beside the power wire (It makes a difference)
ttr125fan09Thread startercorpus christi, texas · Sep 3, 2011#8
the hu is a kdc-138, i need an adapter for the rca cables right?
BEEFnorth carolina · Sep 3, 2011#9
according to this picture (http://www.sonicelectronix.com/pictu...ture_id=172469) you already have RCA outputs on the back.

I don't know anything about the radio and am just going by the pics. I would just wait until you get it and go from there. get some good shielded cables and run them on the opposite side of the car. thats what we always did...back in the day. run them beside the power wire and expect some noise. it is more hassle to tear up both sides of the car but it is the details that make the difference.
ttr125fan09Thread startercorpus christi, texas · Sep 4, 2011#10
So what your saying is basically if i run my power on the passenger side, run my rca on my drivers side, so there no interference right?
BEEFnorth carolina · Sep 4, 2011#11
basically yes.

I know guys that have ran them together without issues. I also know guys that had horrible noise and racket and couldn't figure it out and I proved that their $75 monster cable was the issue because it was butted up against the power wire. I used a $5 RCA cable once to prove this. we just unplugged his and ran it through the car (temporarily) back to his amp and voilia, all his issues went away.

one thing also is to use the same size ground as you do power wire. you don't want the RPM humm in their either.

I don't like going much below 10 gauge but that is a personal preference for me. my largest was 4 gauge and I will admit it was probably overkill but that is just how I roll.

good luck on your project.