Yarisworld Archive

Yaris not starting after major engine repair

9 posts · 4,284 views

SWLOriginal postMorris, Alabama · May 11, 2011#1
My daughter drove her 2007 Yaris hot (three times) and warped the head - Being an old shade tree mechanic I thought I would save her some money and do the job myself. I tore it down had the head resurfaced and reworked and put it all back together carefully, following the online yaris service manual step by step - Now I cannot get any fire to the ignition - It does NOT have the engine immobilzation system ( it was an option in 2007 in US) - I have checked the sensors (Crankcase, camshaft positioning sensors) and they fall within specs - I asked a local mechanic and he thought that my ECU needed reprogramming by the dealer - Is this possible? I can find no mention of it in the service manual online. What else could keep me from getting fire to the plugs? I checked the ECU fuses - all ok - checked the harness - all ok - the car was running (badly) when it tore it down - I'm at my wit's end. Any advice would be appreciated.

Replies 8

JumpmanYarisSO. INDIANA · May 11, 2011#2
Are you getting electricity ?
CTScottUSA, CT · May 11, 2011#3
The ECU definitely doesn't need reprogramming. Do you have an OBDII code reader that you can plug in to make sure that the ECM is actually alive?
Betriventedmonton · May 11, 2011#4
Might be silly but.. is the battery still alive?
SWLThread starterMorris, Alabama · May 12, 2011#5
Thanks for the posts! I do have a reader and the ECU is alive - I am getting electricity to the places I am supposed to .... except the plugs - It spins like a tops but never hits - I took out the plugs and followed the service manual procedure for testing for fire to the plugs - no spark - these are new irridium plugs ($8 each!) I have gone so far as to take a volt/ohm meter and check the ecu and harness to make sure that the pins that go to the various parts of the ignition system are alive and they are.... I guess I am going to have to have it towed to a dealer. Thanks for the input!
CTScottUSA, CT · May 12, 2011#6
Check the AM2 fuse in the under hood fuse panel.
Hersheynortheast · May 12, 2011#7
Hmmmmmmmm .Timing off ? 🤷
Flipper_1938Kentucky · May 12, 2011#8
How is the ignition triggered in our motors?

Could the cams be 180* out of phase with the crank/ignition?
p123456789dirty south · May 14, 2011#9
scan for codes and go from there.