Yarisworld Archive

heat shield over manifold came loose, help?!?

9 posts · 6,535 views

jeff69diniOriginal postCanada · Sep 11, 2010#1
2007 Yaris Sedan, the heat shield over the manifold in the engine area came loose and rattles on the exhaust, only like a cm or 2 free play but enough to rattle

The 2 bolts on top are fine and still solid but the bottom 2 bolts I see there, I can't figure it out, looks like they never held it down in the 1st place unless something else rusted off

can anyone shed any light on this for me? thanks

Replies 8

jeff69diniThread starterCanada · Sep 11, 2010#2
actually looks like 4 x 10mm bolts hold the shield down, is that correct?
Bluevitz-rsOshawa, Ontario, Canada · Sep 11, 2010#3
^sounds about right
jeff69diniThread starterCanada · Sep 13, 2010#4
oh great, looks like the bottom 2 bolts are completely rusted and the metal bracket is completely gone, only 2 upper bolts held it, wonder if its ok to remove the shield altogether?
Bluevitz-rsOshawa, Ontario, Canada · Sep 13, 2010#5
If you have some copper house wireing, you can strip it down so it's bare copper and tie it to manifold with that. It's better to have the heat shield left on.
jeff69diniThread starterCanada · Sep 13, 2010#6
thanks, I'll try that, can I pick up one of the bolts holding it at a local hardware store as I ruined one? lol
127.0.0.1NE · Sep 13, 2010#7
it is OK to remove the shield

but if you get stuck in traffic on a hot day you could
get some serious heat damage in the floor. best to get the heat shield fixed, or mcgyver your own.
jeff69diniThread starterCanada · Sep 14, 2010#8
hmm, I can't find one of those bolts that hold the shield on for the life of me, hopefully I don't have to go to toyota for it :P
jeff69diniThread starterCanada · Sep 14, 2010#9
ok ok, finally found a bolt, lol.........plus gonna use a huge clamp to hold the bottom part on......damn rust