Yarisworld Archive

Need your help installing Tein Basic coilovers for rear canot get spring seated

12 posts · 4,607 views

DeathBeardOriginal postLos Angeles, CA · Aug 29, 2010#1
Hey all,

just recieved some Tein Basic Coilovers from Garm..Installed the front easily and got stuck on the rear..According to Tein directions it states that there is a thrust washer that sandwiches between the spring and height adjuster..My kit came with a rubber collar that the thrust washer sits on..Problem is when i use the rubber collar and thrust washer together I cannot get my spring to be fully seated..I have included a link below that shows the rubber washer sandwiched between the height adjuster and thrust washer for the rear..


Anyone have trouble getting their rear spring to get seated?


Link to a thread or page that is not in the archive

Replies 11

DeathBeardThread starterLos Angeles, CA · Aug 30, 2010#3
Here is the part in question

1 attachment not included in this copy

JumpmanYarisSO. INDIANA · Aug 30, 2010#4
Did you lowered the perch? It will sit in when the car is lowered from jack stands, you have a picture how is looking right now
DeathBeardThread starterLos Angeles, CA · Aug 30, 2010#5
yes the rear perch is lowered to the max..When I installed the rubber collar and thrust washer together I couldn't get the bottom of the rear spring to be fully seated, so I am using just the thrust washer by itself..Will post up pics shortly
Klink10910 · Aug 30, 2010#6
I'm going to ask if you have the rear shocks in and cinched up? If so try loosening those to allow for the axle to lower some more then attempt to install the rubber cushions with the metal thrust washer. Just a thought.
DeathBeardThread starterLos Angeles, CA · Aug 31, 2010#7
ok guys got it figured out..Called Tein and they have a revised top height adjuster that has a built in spring guide so no rubber bushing needed(you can see the part number on pg9 of the tein pdf) ..I was fortunate to work close to Tein and drove there to pick up the new adjusters, the tech came out and said it was extremely dangerous to drive without the bushing as the spring could basically pop out..now the spring sits perfectly..Will get some pics up tomorrow
Klink10910 · Sep 1, 2010#8
Outstanding. However in looking at the page you indicate, I don't see anything as described as "top height adjuster". Would you please re-confirm the name of that piece according to the PDF. I for one am interested and would want to make sure a kit on the market contains it rather than buy the kit only to find out that it too is like yours. Thanks
DeathBeardThread starterLos Angeles, CA · Sep 1, 2010#9
They refer to it as a spring seat lock part number LSS01-L3684-1 below is a pic of my car as it stands now on tein basics..

3 attachments not included in this copy

DeathBeardThread starterLos Angeles, CA · Sep 1, 2010#10
Properly seated rear spring..you can see there is no longer a rubber bushing

2 attachments not included in this copy

DeathBeardThread starterLos Angeles, CA · Sep 1, 2010#11
new scion headunit

1 attachment not included in this copy

Klink10910 · Sep 1, 2010#12
Sweet yes very sweet. Thanks for coming back with the info.