Yarisworld Archive

Keyless entry dead?

7 posts · 5,672 views

AothachosOriginal postLong Island, NY · Jun 13, 2010#1
Just started today out of no where, I hit my lock/unlock button to open my car and it didn't work at all, I looked at my key and pressed it and the red little light comes on so the key isn't dead, not sure what happened, any ideas"?

Replies 6

djct_wattThailand · Jun 13, 2010#2
1. If the locks are locking and re-unlocking, then check all your doors, and your hatch in particular (if you drive a hatch)

2. If not, check your power locks from inside the car via the inside controls. Do they work? If not, check your fuses.

3. If your power locks still work, then your RKE is out of sync with the key. . . it happens, particularly if you like to click the remote out of range like a toy, or if something often hits the button in your pocket. In this case, take it to a Toyota dealer and they can resync it, which takes about 1 minute. I had to do this with my tC, and they did not charge me.
CTScottUSA, CT · Jun 14, 2010#3
If you have the factory keyless, the post below will allow you to test to see if the receiver is alive, and if so, also shows you how to "relearn" a remote.

keyless entry broken?
ProhibitOklahoma City · Jun 14, 2010#4
Could be worse, your door POPPERS could be doing this :( lol.
AothachosThread starterLong Island, NY · Jun 14, 2010#5
power locks and all work perfectly fine, the key isn't dead i see the little red light go on when i hit a button, most likely out of sync because i always have problems with my other keys on my key ring hitting the buttons on it lol
djct_wattThailand · Jun 14, 2010#6
Follow the instructions CTScott posted and it should cure the problem. . . or see if you can get it a dealer to do it free. It's a fairly easy process.
AothachosThread starterLong Island, NY · Jun 15, 2010#7
i just did it yesterday after work in the parking lot lol i was getting laughed at by my gf cuz i looked dumb lol but it works now thanks :D