Yarisworld Archive

Test fitting my new lip kit...

4 posts · 4,474 views

YarisSedanOriginal postCalifornia - Bay Area · May 14, 2010#1
Special thanks to Brian for the sweet deal and Jonathan for driving it back from toyotafest and Sean for storing it for a few days.

Heres a couple test fit pictures. Will post pictures once they are painted and fully installed. Removed the mounting tape for the front and rear. This way it blends more clean and seamless with the bumper. Gona glue it in place on the top where there would be mounting tape with silicon and then bolt it in place at the bottom.

Picture not included in this copy
Picture not included in this copy
Picture not included in this copy

Couldnt get the front lip on yet cause i have to remove my black lip first. Im gona wait till im ready to fully install it. Should be ready to sent to the bodyshop in a week or two. I have to do some minor fiberglass to a small crack on the front lip and a burn mark on the back one from the exhaust and then sand and primer.

Replies 3

BrianRiverside, CA · May 14, 2010#2
Sorry about the minor imperfections but the lip kit has held up for me very well the past 3 years. Did you find the mounting hardware for the side skirts? Here's some pics of the clips.

Picture not included in this copy
Picture not included in this copy
Picture not included in this copy
Picture not included in this copy
YarisSedanThread starterCalifornia - Bay Area · May 15, 2010#3
I am gona see if i can use the hardware that holds the black plastic trim thats already installed on my car already in place of the lip. Gona carefully remove them and try to see if they will work. If not ill probably just purchase some new ones from the dealer. Minor imperfections are no problem since im gona have them repainted anyways. Thanks again.
enviriCT · May 15, 2010#4
if that clip is part# 76923-52021, the few dealers around me are requesting a little over 6 bucks each. i needed 16 of them...bought them online for MUCH cheaper.