AznGoukiOriginal postCalgary · Aug 15, 2009#1Ok just doing the install on the pullies and I got the belt loose but now how do I take the 11mm nut off the crank pulley? It spins when I try to take it off. Just wondering how you guys kept it from moving.
Rich
Replies 4
KioshiFremont, CA · Aug 15, 2009#2AznGoukiThread starterCalgary · Aug 15, 2009#3Nevermind. Good on the Crank. Waterpump is the real issue at hand now.
KioshiFremont, CA · Aug 15, 2009#4Refer to the DIY on here, it helps. I used it for my mechanic who is unfamiliar w/ the Yaris.
It takes about 2 hours, at least my mechanic did :P
AznGoukiThread starterCalgary · Aug 15, 2009#5I looked off it too. No reference as to how they stopped the pullies from turning though. Everybody used impacts on and off probably. I'm using hand tools and a breaker bar. With a little improvisation I got the Crank done. Alternator is another story. I can't figure out how to get that pulley or the water pump pulley off at all.