Turns out the best "rag" for slipping between the crank and the door car is the lanyard from an ID badge. Flat, stiff, and strong.
30 seconds door panel removal (Liftback)
63 posts · 120,965 views · page 2 of 2
Replies continued
Bleargh. "30 seconds" :P
Based on "30 seconds", I figured if I have an hour of daylight left, I should be fine. Sadly, the carefully balanced door card hopped off the curb and the wires operating the door lock and handle jumped out off their designated positions. A green one and a white one. I guess I'll have all day tomorrow to figure out which one goes where.
Based on "30 seconds", I figured if I have an hour of daylight left, I should be fine. Sadly, the carefully balanced door card hopped off the curb and the wires operating the door lock and handle jumped out off their designated positions. A green one and a white one. I guess I'll have all day tomorrow to figure out which one goes where.
you are a legened. power window master switch which just set it self on fire just littery 1 hour ago i need to try and repalce it and this is going to save me.
That's one of the recalls!
I know this has been covered a bit, but I still can't figure out how to get the window crank handle back on. In which order do the handle, washer, and clip go together?
Reinstall
Panel -> Washer -> Clip -> Handle
Panel -> Washer -> Clip -> Handle
Adding to WeeYari, it's best to install the clip on the handle first, then install the washer, then push the whole assembly into the panel. The clip will eventually click into the groove of the splined crank of the panel. I personally prefer to install the assembly with the handle facing up and a bit toward the windshield while the window is up so it'll be easier to crank the window down.
Ok so my question is how does the clip fit back in to the handle? Mine seems way to small to go around the plastic round part of the handle. There are holes in the round part though, does the clip clip in there or something?
The part facing up on the end of the handle is the 'round part' that I was talking aboutDAMN! Your image is HUGE!
Here, image taken from Miata website. Very similar.
Here, image taken from Miata website. Very similar.

Buh ya it is, sorry about that. And ok awesome that's what I was thinking but didn't want to finagle it to try. Thanks, I'll go out and give it a try right now..... and got it in the first shot, thanks for the picture!
Yeah, attach the clip to handle first, and she will just snap back into place. That is why the spline is rounded over on the end to allow it to spread the clip as you slid the handle back onto it.
Hello,
Great DIY.
I knew this thread is "old" but still gold. I just want to ask for any tips when removing
everything? Because my right side mirror is broken i have to replace whole thing (eletronic is working but plastic broken).
And one more question , any problem with replacing mirror cuz of cables ? (for mirror moving)
Great DIY.
I knew this thread is "old" but still gold. I just want to ask for any tips when removing
everything? Because my right side mirror is broken i have to replace whole thing (eletronic is working but plastic broken).
And one more question , any problem with replacing mirror cuz of cables ? (for mirror moving)