Yarisworld Archive

Bypassing the passenger seat sensors!

6 posts · 5,450 views

fujiOriginal postHonolulu · Jun 8, 2009#1
I have read another thread that a resistor may be a way to bypass the sensors on the passenger seat.

Any ideas how to do this? More and more of us are installing aftermarket seats.

There has to be a way to keep it "ON" all the time.
690.jpg

Replies 5

CTScottUSA, CT · Jun 8, 2009#2
I posted a response on another thread about a method that may work.

Finally...Bride Racing Seat Installed

In JM350's thread he mentioned that unplugging the sensors will cause the SRS to get in a state that requires resetting by a Toyota tech. I don't think that is really true based on this quote from the SRS portion of the service manual:

"When the negative (-) terminal cable is disconnected
from the battery, the memory will be cleared.
Therefore make a record of the contents stored in
each system before starting work. When the work is
finished, reset each system as it was before. Never
use a back-up power supply from outside the vehicle
to avoid erasing the memory in any system."
fujiThread starterHonolulu · Jun 9, 2009#3
Thanks for the instuctional CTScott. Has anyone tried this yet???
CTScottUSA, CT · Jun 9, 2009#4
I don't think anyone has.
goku87AK · Aug 6, 2009#5
so basically if i want to take my seats out and put them back in, to avoid having to go to the dealer i just disconnect the battery?

...whats the catch? because that is waaaay to simple.
CTScottUSA, CT · Aug 6, 2009#6
No catch. If you don't start the car, while the seat is out, the SRS system won't even log an error code.